Raspberry Pi 3 Starter Kit Ultimate Learning Suite 1602 LCD SG90 Servo LED Relay Resistors


In stock

$41.20 Wishlist Compare

Raspberry Pi 3 Starter Kit Ultimate Learning Suite 1602 LCD SG90 Servo LED Relay Resistors
Package Contents:
1 x Solderless Prototype Breadboard
1 x T-type GPIO Extension Board
1 x 40 Pin Ribbon Cable
1 x 1602 I2C LCD Module
1 x SG90 Servo Motor
1 x 5V 1- Channel Relay Module
1 x DHT11 Temperature/Humidity Sensor Module
1 x BMP180 Pressure/Temperature Sensor
1 x HC-SR501 Infrared PIR Motion Sensor Module
3 x Potentiometer
1 x Mercury Switch Sensor Module
1 x 8 Channel Logic Level Converter
1 x   MCP3008-CI/P   Analog to Digital Converter
1 x Piezo Buzzer
1 x Infrared Receiver(VS18338B)
1 x Infrared Remote Controller
3 x GL5616 Photoresistor(light sensor)
5 x Push Buttons
24x LED (6 x Bright White, 6 x Red, 6 x Yellow, 6 x Green)
56x Jumper Wires(1 x 40pin male to male 15cm,2 x 8pin female to female 20cm)
60x Resistors(4 Values*15pcs)
Raspberry-Pi-3-Starter-Kit-Ultimate-Learning-Suite-1602-LCD-SG90-Servo-LED-Relay-ResistorsRaspberry-Pi-3-Starter-Kit-Ultimate-Learning-Suite-1602-LCD-SG90-Servo-LED-Relay-Resistors (1)Raspberry-Pi-3-Starter-Kit-Ultimate-Learning-Suite-1602-LCD-SG90-Servo-LED-Relay-Resistors (1)5-Pcs-Set-1602-LCD-Module-Display-5V-Serial-IIC-I2C-TWI-For-Arduino-UNO-R38
86085-Free-shipping-SG90-Mini-Micro-Servo-for-RC-for-RC-250-450-Helicopter-Airplane-Car 20161123_124451 20161123_124504
Because of the IOT project needs wifi function so it is just available for Raspberry Pi 3 experiment ,not available for other Raspberry Pi board , pls take attention ,thank you .
Steps to run IOT project with our kit
Step 1: Register a Free account on cayenne.mydevices.com
Step 2: login into cayenne.mydevices.com Download myDevices Cayenne Smartphone App from Apple Store or Google Play.
Step 3: install client software on pi:If you are logged in for the first time, you will see two linux command lines as follows:
Type and run the two commands above in your Raspberry pi terminal window and install cayenne client in Pi.
Make sure Raspbian OS is freshly installed in your Raspberry Pi and Internet is connected to Pi,then install Cayenne client software on Raspberry Pi by typing the following two commands in Pi command window.
Your Pi will download and install some client software, this might take about 5 to 10 minutes depending on your internet speed.
Step 4: Begin our first project!
Once your client installation is done, in Cayenne's control panel page you will see a Raspberry Pi icon in the upper left hand corner.
If you can not see this button, click User menu -> Triggers & Alerts.